Quick Start Guide

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Select 2008-2013 BMW 1-Series Vehicles - Black

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

Metra. The World’s Best Kits.



INSTALLATION INSTRUCTIONS

95-9315B

KIT FEATURES

• ISO DDIN radio provision

• Painted to match the factory ﬁnish

KIT COMPONENTS

• A) Radio housing • B) Radio brackets • C) Switch panel cover • D) Ribbon cable

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• Cutting tool

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation ....................................................2-3

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: LC-BMRC-01 (non-ampliﬁed models)

Antenna Adapter: 40-EU10

A CB

BMW 1 Series (without NAV, with automatic climate control)

2008-2013

Summary of content (4 pages)

PAGE 1
95-9315B I N S TA L L AT I O N I N S T R U C T I O N S BMW 1 Series (without NAV, with automatic climate control) 2008-2013 KIT FEATURES • ISO DDIN radio provision • Painted to match the factory finish WIRING & ANTENNA CONNECTIONS (sold separately) Wiring Harness: LC-BMRC-01 (non-amplified models) Antenna Adapter: 40-EU10 KIT COMPONENTS • A) Radio housing • B) Radio brackets • C) Switch panel cover • D) Ribbon cable A B C TABLE OF CONTENTS Dash Disassembly.............................................
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the dash trim panel above the radio and glove box. 1. Using a cutting tool, remove the sections of sub-dash indicated to provide clearance for the radio and climate controls. (Figure A) 2. Unclip the climate control panel, then unplug and remove. 3. Unclip the switch panel below the climate control panel (if equipped), then unplug and remove. 4. Unclip and remove the climate controls from the climate control panel. 5.
PAGE 3
KIT PREPARATION 4. Attach the White connector from the ribbon cable supplied with the kit to the circuit board. ISO DDIN radio provision 1. Attach the radio brackets to the radio using the screws supplied with the radio. (Figure A) 5. Reinstall the circuit board back into the switch panel. 6. Clip the climate control panel, and switch panel, into the radio housing. (Figure C) 7. Attach the Black connector from the ribbon cable to the climate control panel. (Figure D) KIT ASSEMBLY (CONT.
PAGE 4
95-9315B I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.