User Manual

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Select 2018 Subaru Vehicles - Black/Silver Trim

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

Metra. The World’s Best Kits.



INSTALLATION INSTRUCTIONS

95-8909

KIT FEATURES

• ISO DDIN radio provision

• Painted black with silver trim

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets • C) (4) Panel clips

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................3

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: 70-1761 (non-ampliﬁed models)

Antenna Adapter: 40-LX11

Steering wheel control interface: Please visit

axxessinterfaces.com for more information

A B C

Subaru Legacy/Outback (all except 2.5i) 2018-up*

*Visit MetraOnline.com for up-to-date vehicle speciﬁc applications.

Summary of content (4 pages)

PAGE 1
95-8909 I N S TA L L AT I O N I N S T R U C T I O N S Subaru Legacy/Outback (all except 2.5i) 2018-up* *Visit MetraOnline.com for up-to-date vehicle specific applications. KIT FEATURES • ISO DDIN radio provision • Painted black with silver trim KIT COMPONENTS • A) Radio trim panel • B) Radio brackets • C) (4) Panel clips A B TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Preparation........................................................3 Kit Assembly.......
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the trim below the climate control panel. (Figure A) 3. Unclip and remove the a/c vent panel. (Figure C) 2. Remove (2) Phillips screw securing the climate control panel, then unclip, unplug, and remove the panel. (Figure B) Tip! Start from the bottom of the panel and release the bottom (2) clips first. 4. Remove (4) Phillips screws securing the radio, then unclip, unplug and remove the radio.
PAGE 3
KIT PREPARATION 1. Slightly loosen (4) screws securing the radio. (Figure A) 1. Secure the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. If the vehicle is equipped with Starlink, remove (4) screws securing the Starlink module (shaded part in figure A) located directly below the radio. The module must be relocated lower in the dash cavity to retain functionality with the front speakers. (Figure A) 3.
PAGE 4
95-8909 I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.