Specifications

ManualsBrandsMetra Manualschassis components95-8902

INSTALLATION INSTRUCTIONS FOR PART 95-8902

95-8902

KIT FEATURES

• Double DIN Radio Provision

• Stacked ISO Mount Units Provision

•A) Radio Housing • B) Double DIN Brackets

KIT COMPONENTS

Small Flat Blade Screwdriver/ Panel Removal Tool

• Phillips Screwdriver

1-800-221-0932

www.metraonline.com

TOOLS REQUIRED:

APPLICATIONS

SUBARU Impreza 2008-11

Forester 2009-11

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 95-8902 APPLICATIONS SUBARU Impreza 2008-11 Forester 2009-11 95-8902 KIT FEATURES • Double DIN Radio Provision • Stacked ISO Mount Units Provision KIT COMPONENTS •A) Radio Housing • B) Double DIN Brackets A B TOOLS REQUIRED: Small Flat Blade Screwdriver/ Panel Removal Tool • Phillips Screwdriver 1-800-221-0932 www.metraonline.
PAGE 2
95-8902 TABLE OF CONTENTS Dash Disassembly - SUBARU Impreza 2008-11/Forester 2009-11 . . . . . . . . . . . . . . . . . . . . . . . . . .1 Kit Assembly - Double DIN Radio Provision /Stacked ISO Mount Units Provision . . . . . . . . .2 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 *Note: Refer also to the instructions included with the aftermarket radio.
PAGE 3
95-8902 DASH DISASSEMBLY SUBARU IMPREZA 2008-11/FORESTER 2009-11 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the trim panel surrounding the factory radio including the a/c vents. (Figure A) 3 Remove (4) Phillips screws securing the radio. Unplug and remove the radio. (Figure B) Continue to kit assembly.
PAGE 4
95-8902 KIT ASSEMBLY DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS PROVISION *Note: Refer also to the instructions included with the aftermarket radio. A 1 Snap the Double DIN brackets to the inside edge of the Radio Housing. (Figure A) 2 Slide the Double DIN or stacked ISO mount unit(s) into the bracket/radio housing assembly and secure the unit(s) to the assembly using the screws supplied with the unit(s). (Figure B) Continue to final assembly.
PAGE 5
95-8902 FINAL ASSEMBLY FINAL ASSEMBLY A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disassembly.
PAGE 6
95-8902 NOTES 4
PAGE 7
95-8902 NOTES 5
PAGE 8
95-8902 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV.