Instructions/Assembly Guide

386.257.1187
|
MetraOnline.com
2
1. Unclip the air vents, unplug and remove
(do not cycle the key while unplugged).
(Figure A)
2. Remove two T-20 Torx from the radio
and lift up on the two tabs located at
each mounting point. (See detail)
3. Slide the factory radio out paying
attention to the runners on the sides.
(Figure B)
(Figure D)
(Figure A) (Figure C)
DASH DISASSEMBLY
4. Unclip the trim at the bottom of the
radio and unscrew the factory buttons to
be relocated to the button trim panel in
kit assembly.
5. Remove two T-20 Torx screws from
the bottom of the factory radio screen
assembly and remove.
Continue to Kit Preparation
Detail