Quick Start Guide

REV. 1/27/2020 INST95-8732B
3
1. Secure the radio brackets to the radio
bezel using (4) Phillips screws provided.
(Figure A)
2. Slide the radio into the bracket/bezel
assembly, then secure using screws
supplied with the radio. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
4. Slide the radio assembly into the dash.
Secure by turning the radio screws just
enough to secure the radio in place. Do
not overtighten. (Figure C)
5. Reassemble the dash in reverse
order of disassembly to complete the
installation.
KIT ASSEMBLY
(Figure A) (Figure C)(Figure B)