User Manual

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Select 2010-2013 Mercedes E-class Vehicles - Black

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

95-8730B

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT FEATURES

• ISO DDIN radio provision

• Includes panel for relocating the factory buttons

• Painted black

KIT COMPONENTS

• A) Radio housing • B) Radio brackets • C) Button panel housing • D) Button panel housing bracket • E) Button panel tabs (2)

• F) Button extension harness • G) Radio screws (4) •H) 3/8” screws (6) •I) 1/4” screws (2)

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• T-20 Torx screwdriver • 3mm Allen screwdriver

• Thin-head ﬂat-blade screwdriver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................3

Kit Assembly ..........................................................4

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: XSVI-9005-NAV (non-amped only)

Antenna Adapter: 40-EU10

A B

E F

Mercedes E Class (W212) 2010-2013

* Left hand drive models only

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle

speciﬁc applications

G H I

Summary of content (4 pages)

PAGE 1
95-8730B I N S TA L L AT I O N I N S T R U C T I O N S Mercedes E Class (W212) 2010-2013 * Left hand drive models only Visit MetraOnline.
PAGE 2
DASH DISASSEMBLY Radio/Button Removal: Display Removal: 1. Open the glove box, then pull down (2) clips securing the a/c vent panel above the glove box opening. (Figure A) 1. Unclip and remove the display bezel trim. There are (4) clips securing the trim to the display. Shown in the figure is the bottom left clip. (Figure E) 2. Locate the release clip inside each center a/c vent. Using a thin-head flat-blade screwdriver, pull out on the release clips to free the a/c vent panel.
PAGE 3
KIT PREPARATION Button Relocation closest to the driver side of the vehicle has (2) dots. (Figures B & C) 1. Connect the button extension harness to the harness removed in step 3 from Dash Disassembly. Route this harness to the display area up top. 2. Remove the button panel from the factory radio: a. Unclip the trim from the bottom of the radio. d. Fully secure the button panel to the assembly using the factory hardware. (Figure D) (Figure A) Housing Assembly b.
PAGE 4
95-8730B I N S TA L L AT I O N I N S T R U C T I O N S If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 1-800-253-TECH, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.