Owner's Manual

REV. 1/8/2019 INST95-8730B
3
Button Relocation
1. Connect the button extension harness
to the harness removed in step 3 from
Dash Disassembly. Route this harness to
the display area up top.
2. Remove the button panel from the
factory radio:
a. Unclip the trim from the bottom of
the radio.
b. Remove (4) screws securing the panel,
then remove the panel. (Figure A)
3. Attach the button panel to the button
panel housing:
a. Slide the button panel under the
top lip of the housing, then click the
bottom in place.
b. Secure the button panel housing
brackets to the housing using (4) of
the 3/8” screws provided. (Figure B)
c. Secure the button panel tabs to
the housing using (2) 1/4” screws
provided. Take note that the tab
closest to the driver side of the
vehicle has (2) dots. (Figures B & C)
d. Fully secure the button panel to
the assembly using the factory
hardware. (Figure D)
4. Connect the button panel to the button
extension harness in the vehicle, then
clip the assembly to the vehicle.
Housing Assembly
5. Secure the radio brackets to the radio
housing using (4) 3/8” screws provided.
(Figure E)
Continue to Kit Assembly
(Figure A)
(Figure B)
(Figure C)
KIT PREPARATION
(Figure E)
(Figure D)