Quick Start Guide

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Select 2009-2011 Mercedes R Class Vehicles - Black

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

95-8728B

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT FEATURES

• ISO DDIN radio provision

• Painted black

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets • C) Radio screws (8) • D) Radio trim panel screws (4)

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• 3mm Allen screwdriver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................3

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness:

XSVI-9005-NAV (non-amped only)

Antenna Adapter: 40-EU10

Steering Wheel Control Interface: • ASWC-1

A B

Mercedes R Class 2009-2011

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle speciﬁc applications

C D

Summary of content (4 pages)

PAGE 1
95-8728B I N S TA L L AT I O N I N S T R U C T I O N S Mercedes R Class 2009-2011 Visit MetraOnline.
PAGE 2
DASH DISASSEMBLY 1. Unclip the climate control panel, then set to the side. No need to disconnect the wiring harness. The tabs holding the panel in place are located on the left and right sides of the panel, towards the top. (Figure A) 2. Remove (2) Torx screws below the radio (white circles in figure), then pull down the metal clips to release the radio. Slide the radio out, then unplug and remove the radio. (Figure B) Continue to Kit Preparation (Figure A) 2 (Figure B) 1.800.221.0932 | MetraOnline.
PAGE 3
KIT PREPARATION 1. Remove the top trim from the factory radio by pulling back on the release tab in the middle, then sliding the trim to the right. Follow the same procedure to attach it to the radio trim panel. (Figure A) 1. Slide the radio into the bracket/panel assembly, then secure the radio using either the screws supplied with the radio, or the radio screws provided. (Figure A) 2. Secure the radio brackets to the radio trim panel using the (4) radio trim panel screws supplied.
PAGE 4
95-8728B I N S TA L L AT I O N I N S T R U C T I O N S If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 1-800-253-TECH, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.