Quick Start Guide

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Select 2003-2006 Mercedes CL-Class Vehicles - Wood Tone

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

Metra. The World’s Best Kits.



INSTALLATION INSTRUCTIONS

95-8727

KIT FEATURES

• ISO DDIN radio provision

• 95-8727B-Finished in black

• 95-8727W-Finished in wood

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• Torx T20 screwdriver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: TBA

Antenna Adapter: 40-VW12

A B

Mercedes-Benz CL Class 2003-2006

Summary of content (4 pages)

PAGE 1
95-8727 I N S TA L L AT I O N I N S T R U C T I O N S Mercedes-Benz CL Class 2003-2006 KIT FEATURES • ISO DDIN radio provision • 95-8727B-Finished in black • 95-8727W-Finished in wood KIT COMPONENTS • A) Radio trim panel • B) Radio brackets A TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Assembly...........................................................
PAGE 2
DASH DISASSEMBLY 1. Open the center console door, then unclip the beauty trim from the front of the center console compartment. 2. Unclip and remove the lower trim from the front of the center console compartment, then remove (2) Torx T20 screws. 3. Turn the chrome trim from the bottom of the shifter slightly counterclockwise, then wiggle the shifter knob upwards to remove it. 4. Unclip, unplug, and remove the beauty trim surrounding the shifter. 5.
PAGE 3
KIT ASSEMBLY 1. Secure the radio brackets to the radio using the screws provided with the radio. (Figure A) 2. Locate the factory wiring harness and antenna connection in the dash, and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess. Test the radio for proper operation. 3. Secure the radio to the dash using the (2) factory screws, to just the lower tabs on the radio brackets. (Figure B) 4.
PAGE 4
95-8727 I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.