User Manual

95-8235CHG
Kit Preparation Kit Assembly
1. Attach the clock/hazard switch
bracket to the radio housing using
the (6) #4 x 3/8” Phillips pan head
screws. (Figure A)
WARNING: DO NOT OVERTIGHTEN
SCREWS.
2. Clip the clock/hazard switch
assembly into the 95-8235CHG
radio housing trim panel.
(Figure B)
3. Install the three included panel
clips to the back of the radio
housing trim panel (factory clips
can also be used if desired).
Continue to kit assembly
(Figure A)
(Figure B)
(Figure A)
3
H
M
PASSENGER
PASSENGER
H
M
PASSENGER
PASSENGER
INSERT CLOCK/HAZARD SWITCH ASSEMBLY
FROM REAR OF 99-8214 RADIO HOUSING TRIM PANEL
Insert Clock/Hazard switch assembly from
rear of 95-8235CHG radio housing trim panel
1. Mount the radio to the radio
brackets with the screws supplied
with the radio. (Figure A)
2. Secure the radio/bracket assembly
into the sub dash using the factory
hardware.
3. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
4. Reassemble dash in reverse order
of disassembly using the
95-8235CHG radio trim panel
instead of the factory panel.