User Manual

ManualsBrandsMetra ManualsAutomotiveMetra 95-8155 Double DIN Installation Kit for 1997-2001 Lexus ES Vehicles

INSTALLATION INSTRUCTIONS FOR PART 95-8155

APPLICATIONS

LEXUS ES SERIES

1997-2001

KIT FEATURES

• Double DIN Radio Provision

• Stacked ISO Mount Units Provision

A) Double DIN Radio Housing

KIT COMPONENTS

TOOLS REQUIRED:

Small Flat Blade Screwdriver/ Panel Removal Tool

• Phillips Screwdriver • Socket Set

1-800-221-0932

TION

www.metr

aonline.com

95-8155

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 95-8155 APPLICATIONS LEXUS ES SERIES 1997-2001 95-8155 KIT FEATURES • Double DIN Radio Provision • Stacked ISO Mount Units Provision KIT COMPONENTS A) Double DIN Radio Housing A TOOLS REQUIRED: Small Flat Blade Screwdriver/ Panel Removal Tool • Phillips Screwdriver • Socket Set 1-800-221-0932 www.metraonline.
PAGE 2
95-8155 TABLE OF CONTENTS Dash Disassembly - Lexus ES Series 1997-2001 . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Kit Assembly - Double DIN Radio Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 *Note: Refer also to the instructions included with the aftermarket radio.
PAGE 3
95-8155 DASH DISASSEMBLY LEXUS ES SERIES 1997-2001 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Carefully pry out and remove small trim panel between ashtray and bottom of climate control. (Figure A) FM2 3 Using a small flat blade screwdriver gently pry out on the top of the A/C vent assembly (including clock) and remove. (Figure B) 4 Remove (4) screws securing the radio/climate control assembly. Unplug and remove assembly.
PAGE 4
95-8155 KIT ASSEMBLY LEXUS ES SERIES 1997-2001 DOUBLE DIN RADIO STACKED ISO MOUNT UNITS PROVISON Note: Refer also to the instructions included with the aftermarket radio. A 1 Assemble the climate controls and Double DIN or stacked ISO mount units into the factory brackets using the hardware from disassembly and the screws supplied with the aftermarket unit(s).
PAGE 5
95-8155 FINAL ASSEMBLY FINAL ASSEMBLY A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation.
PAGE 6
95-8155 NOTES 4
PAGE 7
95-8155 NOTES 5
PAGE 8
95-8155 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV.