User Manual

95-7862
Kit Assembly
(Figure A)
(Figure B)
(Figure C
ISO DDIN radio provision 1. Attach the two included panel clips
to the radio housing. (Figure A)
2. Attach the brackets to the radio
housing trim panel using the two #8 x 3/8” screws supplied. (Figure B)
3. Slide the radio into the bracket/
radio housing assembly from behind and secure to the assembly using the screws supplied with the radio. (Figure C)
4. Make wiring connections using the
Metra/EIA Wiring Code chart shown on back page, and the instructions included with the radio.
5. Disconnect the main harness from
the factory radio, and connect the included Radio “T” Harness between this harness, and the OE radio.
6. Reassemble dash in reverse order
of disassembly.
3