Installation Guide

1.800.221.0932
|
MetraOnline.com
6
KIT ASSEMBLY
1. Attach the (4) panel clips to the radio
housing . (Figure A)
2. Attach the radio brackets to the radio
housing using the supplied (4) #8 x 3/8”
pan-head Phillips screws. (Figure B)
3. Slide the radio into the bracket/radio
housing assembly and secure to the
assembly using the screws supplied
with the radio. (Figure C)
4. Attach the A/C vents to the radio
housing using the factory hardware.
5. Attach the hazard switch to the radio
housing using the supplied (2) #8 x 1/2”
truss-head Phillips screws.
6. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Test the unit for proper
operation.
7. Reassemble the dash in reverse order of
disassembly.
(Figure A) (Figure C)
(Figure B)