User Manual

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Select 2017 Kia Sportage LX Vehicles - Matte black

REV. 2/10/2017 INST95-7378B

INSTALLATION INSTRUCTIONS FOR PART 95-7378B

METRA – The World’s best kits.

metraonline.com

CAUTION!

All accessories, switches, climate controls panels, and

especially air bag indicator lights must be connected before cycling

the ignition. Also, do not remove the factory radio with the key in the

on position, or while the vehicle is running.

• ISO DDIN radio provision

• Painted scratch resistant matte black

• A) Radio trim panel • B) Radio brackets

KIT FEATURES

KIT COMPONENTS

WIRING & ANTENNA CONNECTIONS (sold separately)

Wire harness: • 70-7304

Antenna adapter: • 40-KI11

• Panel removal tool • Phillips screwdriver

• Torx screwdriver

TOOLS REQUIRED

Kia Sportage 2017-up (with 5” screen)

95-7378B

Table of Contents

A B

Dash Disassembly ................................................. 2

Kit Preparation ....................................................... 3

Kit Assembly .......................................................... 3

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 95-7378B Kia Sportage 2017-up (with 5” screen) 95-7378B Table of Contents Dash Disassembly.................................................. 2 Kit Preparation........................................................ 3 Kit Assembly........................................................... 3 KIT FEATURES • ISO DDIN radio provision • Painted scratch resistant matte black KIT COMPONENTS • A) Radio trim panel • B) Radio brackets REV.
PAGE 2
95-7378B Dash Disassembly 1. Unclip and slide the top of the center console (including the cup holders) back slightly. (Figure A) 2. Open the passenger door, and then unclip and remove the dashboard trim panel. Remove (1) Phillips screw exposed. (Figure B) 3. Unclip and remove the entire panel that is above the glove box, and below the radio. (Figure C) 4. Remove (2) Phillips screws from the radio/vent panel, and then unclip and remove. (Figure D) (Figure A) (Figure C) (Figure B) (Figure D) 5.
PAGE 3
95-7378B Kit Preparation Kit Assembly From the factory radio/vent panel: ISO DDIN radio provision 1. Remove (4) screws securing the inner radio trim panel to the panel, and then unclip and remove. (Figure A) 1. Attach the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. Attach the 95-7378B radio trim panel to the factory radio/vent panel, and then secure using the factory hardware. (Figure A) 2.
PAGE 4
INSTALLATION INSTRUCTIONS FOR PART 95-7378B IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling. KNOWLEDGE IS POWER REV.