Owner's Manual

ManualsBrandsMetra ManualsAudio accessories & installationDash Kit

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

95-6547B

KIT FEATURES

• ISO DDIN radio provision

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets • C) Cut template

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• T20 Torx screwdriver • Cutting tool • File

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................3

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: 70-1817 (2001) • 70-6502 (02-04)

Antenna Adapter: N/R (2001) • 40-CR10 (02-04)

A B C

Dodge Dakota 2001-2004 / Durango 2001-2003

Summary of content (4 pages)

PAGE 1
95-6547B I N S TA L L AT I O N I N S T R U C T I O N S Dodge Dakota 2001-2004 / Durango 2001-2003 KIT FEATURES • ISO DDIN radio provision TABLE OF CONTENTS Dash Disassembly ..................................................2 Kit Preparation .......................................................3 Kit Assembly ..........................................................
PAGE 2
DASH DISASSEMBLY 1. Remove (3) T20 Torx screws from the bottom edge of the panel below the steering column, then unclip and remove the panel. (Figure A) 2 Screws 2. Remove (2) Phillips screws from the instrument cluster panel above the gauges. (Figure A) 3. Remove (3) T20 Torx screws from the bottom of the steering column shroud, then unclip and remove just the top half of the shroud. (Figure A) 3 Screws 4. Unclip the entire dash panel surrounding the radio, climate controls, and instrument cluster.
PAGE 3
KIT PREPARATION KIT ASSEMBLY 1. Remove (4) Phillips screws securing the climate controls, then remove them in preparation for the following steps. 1. Secure the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. Place the cut template over the factory dash panel. (Figure A) 2. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess.
PAGE 4
95-6547B I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difﬁculties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.