Quick Start Guide

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Select 05/2017 Jeep Compass Vehicles - Matte Black

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

Metra. The World’s Best Kits.



INSTALLATION INSTRUCTIONS

95-6545B

KIT FEATURES

• ISO DDIN radio provision

• Painted matte black

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets • C) (7) Panel clips

A B C

Jeep Compass 2017.5-up*

*Visit MetraOnline.com for up-to-date vehicle speciﬁc applications.

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wire harness: • XSVI-6523-NAV

Antenna adapter: • 40-EU10

Steering wheel control interface: ASWC-1

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................2

Kit Assembly ..........................................................3

Summary of content (4 pages)

PAGE 1
95-6545B I N S TA L L AT I O N I N S T R U C T I O N S Jeep Compass 2017.5-up* *Visit MetraOnline.com for up-to-date vehicle specific applications. KIT FEATURES • ISO DDIN radio provision • Painted matte black TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Preparation........................................................2 Kit Assembly...........................................................
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the a/c vent panel surrounding the radio. 1. Attach the (7) panel clips to the radio trim panel. (Figure A) 2. Remove (4) 9/32” screws securing the radio, then unplug and remove the radio. Continue to Kit Preparation KIT PREPARATION Continue to Kit Assembly Please visit Metraonline.com for Dash Disassembly illustrations. (Figure A) 2 1.800.221.0932 | MetraOnline.
PAGE 3
KIT ASSEMBLY ISO DDIN radio provision 1. Attach the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/ or Axxess. 3. Test the radio for proper operation. 4. Secure the radio assembly to the dash using the factory screws. 5.
PAGE 4
95-6545B I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.