Quick Start Guide

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Select 2007-2014 Lincoln Navigator Vehicles - Silver

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

Metra. The World’s Best Kits.



INSTALLATION INSTRUCTIONS

95-5845S

KIT FEATURES

• ISO DDIN radio provision

• Painted silver to match the factory appearance

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets

A B

Lincoln Navigator 2007-2014

Intended for 4x4 models without factory NAV

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• 8mm, 7/32” and 9/32” socket wrench

• T-20 Torx driver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................3

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: Please visit metraonline.com for

interface options

Antenna Adapter: 40-CR10

Summary of content (4 pages)

PAGE 1
95-5845S I N S TA L L AT I O N I N S T R U C T I O N S Lincoln Navigator 2007-2014 Intended for 4x4 models without factory NAV KIT FEATURES • ISO DDIN radio provision • Painted silver to match the factory appearance TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Preparation........................................................3 Kit Assembly...........................................................
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the panel surrounding the shifter. (Figure A) 2. Remove (2) 9/32” screws from the bottom of the radio/climate control trim panel, and then unclip and remove. (Figure B) 3. Remove (4) 9/32” screws securing the radio and then remove. Radio/climate control trim panel disassembly: 4. Remove (4) Torx T-20 screws and remove the factory pocket/ ashtray assembly from the factory dash panel. (Figure C) (Figure A) 5.
PAGE 3
KIT PREPARATION 1. Place the radio trim panel into the factory dash panel and secure with the (6) T-20 screws and (4) push nuts removed in Dash Disassembly. (Metra recommends a small 8mm socket for pressing them on). (Figure A) KIT ASSEMBLY 1. Attach the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. Locate the factory wiring harness and antenna connector in the dash, and complete all necessary connections to the radio.
PAGE 4
95-5845S I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.