Owner's Manual

FIGURE 2

Shaft Supports

Installation Kit

Tools Required

120 92-3300P

Chevrolet

1. Press posts on trimplate into holes on kit frame to

snap parts together and secure with hex screws

(Figure 1).

2. Use a utility knife to cut out shaft supports in

trimplate to create a DIN opening (Figure 2).

3. Push clips on support tray into slots on rear of kit

frame to secure (Figure 1).

4. Secure side mounting brackets to kit frame with

studs and nuts supplied (Figure 1).

5. Remove DIN sleeve from receiver and slide into

opening in trimplate. Secure sleeve to trimplate by

bending the securing tabs (Figure 3).

6. Slide receiver into sleeve/kit assembly.

DIN Receiver Assembly

Utility

Knife

FIGURE 3

Securing Tabs

DIN Sleeve

Bend tabs after sleeve

is inside assembly.

▲

Small Flat Blade

Screwdriver

FIGURE 1

Trimplate

Kit Frame

Support Tray

Mounting Bracket

Stud

Nut

1/4” & 3/8”

Sockets

Hex Screws