Owner's Manual

Side Mounting Bracket

FIGURE 1

Kit Frame

Stud

Nut

Support Tray

Trimplate

DIN Sleeve

Dash Kit

120 90-3018P

Chevrolet

1. Press posts on trimplate into holes on kit frame to snap

parts together and secure (Figure 1).

2. Push clips on support tray into slots on rear of kit frame

to secure (Figure 1).

3. Secure side mounting brackets to kit frame with studs

and nuts supplied (Figure 1).

4. Remove DIN sleeve from receiver and slide into opening

in trimplate. Secure sleeve to trimplate by bending the

securing tabs (Figure 2).

5. Slide receiver into sleeve/kit assembly.

6. Connect receiver wiring adaptor to receiver following

instructions received from Crutchfield.

7. Connect receiver wiring adaptor to vehicle harness and

plug antenna lead into rear of receiver. Secure receiver

assembly to dash with screws previously removed.

8. Test receiver operation and reassemble dash by reversing

disassembly steps.

Receiver Assembly & Installation

FIGURE 2

Securing Tabs

Bend tabs after

sleeve is inside

assembled kit.

Page 2

IMPORTANT

Before starting, compare items on your invoice with items

received. Carefully check through packaging material. If an

item is missing, please call Crutchfield at 1-888-955-6000.