Owner's Manual

Violet/Black - Right Rear Speaker NegativeViolet - Right Rear Speaker Positive

Green - Left Rear Speaker Positive

Gray - Right Front Speaker Positive Gray/Black - Right Front Speaker Negative

Green/Black - Left Rear Speaker Negative

White/Black - Left Front Speaker NegativeWhite - Left Front Speaker Positive

Yellow - 12V Constant Power

Black - Chassis Ground

Orange - Illumination

Red - 12V Switched Power

Blue - Power Antenna

Green/Orange - Connect to the Steering

Wheel Control Interface SWC Signal

Thin Black - Connect to the Steering

Wheel Control Interface SWC Ground

Blue/Pink - Vehicle Speed Sensor

These wires cannot be used

in the 2016- Kia Sorento (tape off)

Receiver Wiring Adaptor

120 70-7304

Revision 07/05/17

STEP 1 -- MATCH & CONNECT WIRES

IMPORTANT

Before starting, compare items on your invoice with items

received. Thoroughly check packing materials. If an item

is missing, please call

Crutchfield at 1-888-955-6000.

Match wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your

new receiver may, or may not, match the wire colors of the adaptor. Match adaptor and receiver wires by function, disregarding color.

Your receiver illumination wire could be Orange or Orange/White. As with other wires, match this wire to the illumination wire in this harness

by function, not by color. If your receiver does not have an illumination wire, tape off the illumination wire.

Individually tape off any unused wires.

Make final wiring connections following instructions on the next page.

*120707304*



PAGE 1
Receiver Wiring Adaptor 120 70-7304 IMPORTANT Before starting, compare items on your invoice with items received. Thoroughly check packing materials. If an item is missing, please call Crutchfield at 1-888-955-6000. Revision 07/05/17 STEP 1 -- MATCH & CONNECT WIRES A. Match wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your new receiver may, or may not, match the wire colors of the adaptor.
PAGE 2
120 70-7304 Receiver Wiring Adaptor Connections Page 2 STEP 2 -- CONTINUED STEP 2 -- CRIMP CONNECTIONS Tools & Parts Required Wire Stripper/Crimp Tool A. Strip wires back 1/2”. Crimp Caps D. Complete crimp connections for all necessary wires. Generic Illustration E. Be sure to wrap any wires from the Wiring Adaptor that are not necessary (wires with no match from the new receiver) with electrical tape. Receiver Wiring Adaptor Unused Wire (tape over bare wires) STEP 3 -- APPLICATION B.