Owner's Manual

ManualsBrandsMetra ManualsAudio accessories & installation30-5512 Dash Kit

1. Set parking brake and disconnect negative battery cable

to prevent any electrical short.

2. Slide DIN trim ring onto DIN sleeve from rear. Pull trim ring

to front of DIN sleeve.

3. Secure “C” bracket to rear support bracket using hardware

supplied. Do not fully tighten screw (Figure 1) Note:

Position guides at the bottom (opposite) for Ford Aerostar.

4. Rotate “C” bracket 90 degrees to allow it to pass through

dash opening (Figure 2), then slide rear support bracket

onto rail in dash opening.

5. Once rear support bracket is in position,

rotate “C” bracket 90 degrees and

fully tighten screw.

6. Install receiver following

instructions supplied with

your receiver.

Installation Kit

Tools Required

120 30-5512

▲

Parts

Supplied:

▲

DIN Trim Ring

Rear Support

Bracket

Revision 09/11/97

FIGURE 1

Phillips

Screwdriver

DIN Receiver Preparation

DIN Sleeve

DIN Trim Ring

Rear Support Bracket

“C” Bracket

*120305512*

Ford

Lincoln

Mercur y

IMPORTANT

Before starting, compare items on your invoice with items

received. If any parts are missing, first carefully check through

packaging material. If an item is missing, please call:

Crutchfield

FIGURE 2

“C” Bracket

(1) “U” Clip

(1) Screw

Guides

at 1-888-955-6000

Summary of content (1 pages)

PAGE 1
Installation Kit 120 30-5512 IMPORTANT Before starting, compare items on your invoice with items received. If any parts are missing, first carefully check through packaging material. If an item is missing, please call: Crutchfield at 1-888-955-6000 DIN Receiver Preparation Ford Lincoln Mercury Revision 09/11/97 1. Set parking brake and disconnect negative battery cable to prevent any electrical short. DIN Trim Ring FIGURE 1 Guides “C” Bracket 2. Slide DIN trim ring onto DIN sleeve from rear.