Owner's Manual

REV. 8/18/2020 INST108-TO6HG
3
KIT ASSEMBLY
Pioneer Modular DDIN radio provision
Note: For steps 1 and 2, reference the
installation manual provided with the radio
for which hardware to use. The display
screen and radio chassis use two different
types of screws.
1. Secure the radio display to the radio
brackets using (4) screws supplied with
the radio. (Figure A)
2. Secure the radio brackets to the radio
chassis using (4) screws supplied with
the radio. (Figure B)
3. Connect the radio display to the radio
chassis.
4. Using a cutting tool, carefully remove
the center cross-shaped support brace
from the radio trim panel.
5. Snap the radio trim panel to the new
radio display. (Figure C)
6. Assemble the radio assembly into the
factory radio panels using the outside
(4) factory screws (screws are also
provided if needed). (Figure D)
7. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
8. Slide the radio assembly into to the
dash, then secure using the factory
screws.
9. Reassemble the dash in reverse
order of disassembly to complete the
installation.
(Figure C)(Figure A)
(Figure B) (Figure D)