Installation Guide

REV. 8/18/2020 INST107-TO1HG
3
Bottom chassis DDIN radio provision
1. Using pliers or cutting tool, remove the
shown inside mounting tabs from the
radio brackets. (leave the smallest inner
mounting tabs) (Figure A)
2. Secure the radio to the radio brackets
with screws supplied with radio.
(Figure B)
3. Secure the radio/bracket assembly to
the radio trim panel using (4) Phillips
screws provided. (Figure C)
4. Secure the radio assembly into the
factory radio panels using (4) of the
factory screws. (screws are also provided
if needed) (Figure D)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
6. Slide the radio assembly into to the
dash, then secure using the factory
screws and snap the trim back in place.
(Figure A)
(Figure C)
(Figure B) (Figure D)
KIT ASSEMBLY
Remove shaded areas