Owner's Manual

1.800.221.0932
|
MetraOnline.com
4
KIT ASSEMBLY
Bottom chassis radio provision
1. Secure the sub-dash brackets to the
dash using the factory screws. (Figure A)
2. Snap off the front of the radio brackets
and secure them to the radio using
screws supplied with the radio.
(Figure B, C)
3. Snap the radio housing into the factory
dash panel. (Figure D)
4. Snap the factory dash panel back
in place.
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
6. Slide the radio assembly into to the dash
and secure to the radio housing using
the (4) included Phillips screws.
(Figure E)
7. Snap the radio trim panel into the
radio housing. (Figure F)
(Figure A) (Figure D)
(Figure B) (Figure E)
(Figure C) (Figure F)
Remove shaded areas