Installation Guide

1.800.221.0932
|
MetraOnline.com
4
(Figure A) (Figure B)
KIT ASSEMBLY
Chassis Top DDIN radio provision
1. Snap the front mounting tabs off of the
radio brackets. (Figure A)
2. Secure the radio brackets to the radio
using screws supplied with the radio.
(Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
4. Slide the radio assembly into to the
dash, then secure using the factory
hardware for the passenger side and
(1) #8 Phillips head screw for the
driver’s side.
5. Clip the radio trim panel to the factory
dash panel.
6. Reassemble the dash in reverse
order of disassembly to complete the
installation.
Remove tabs