Instruction Manual

7
REV. 3/5/2021 INSTMPS-DSPX-RC1
From the configurations page you should first test
your system to make sure everything is connected
properly after the DSP. To test your setup select the
IDENTIFY button. This will play a chime thought
your setup to confirm your system is ready to pass
audio. (Figure 1)
Next select your VEHICLE TYPE (Figure 1)
The MPS-DSPX-RC1 will be set to Polaris for the
Make. Next, select your Model, RZR or General. If
you have a Ranger select General as your model,
keep “Without OE Amp” selected, then select
Apply. (Figure 2)
(Figure 1)
(Figure 2)
QUICK SETUP GUIDE (CONT.)
DSP Setup & Controls (Cont’d)
Continued on the next page