Instruction Manual

I N STALL ATI ON

1. With the arrow stamped onto the cap facing upwards, push the 16-pin connector from the

MPS-DSPX-RC1 harness into the left side of the cap. The locking clip on the connector should

face upward. Make sure the gasket is seating properly in the cap. (Figure A)

2. With the arrow stamped onto the cap still facing upwards, push the 20-pin connector from

the MPS-DSPX-RC1 harness into the right side of the cap. The locking clip on the connector

should face upward. Make sure the gasket is seating properly in the cap. (Figure A)

3. Plug the 16-pin and 20-pin connectors from the MPS-DSPX-RC1 harness into the

MPS-DSPX-RC1 circuit board. (Figure A)

4. Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure location

to secure it. Make sure the logo is facing up to further ensure that no outside elements can

enter the enclosure.

5. Gain access to the rear of your Ride Command Screen. Refer to your Service manual for

instructions. Each Audio Amp connector is located in the upper dash compartment. Match up

Amp1, Amp2, and Amp3 connectors to each other and plug in.

6. Download and install the AX-DSP-XL app from the Google Play Store or Apple App Store.

7. Open the app and follow the instructions on the Bluetooth Connection tab to pair the mobile

device to the MPS-DSPX-RC1.

8. Scroll to the Conﬁguration tab then select Polaris as the vehicle type. Then select your

model. Keep without OE ampliﬁer selected regardless of the OE system type.

9. Connect the amp turn-on wire from the MPS-DSPX-RC1 to your aftermarket ampliﬁers.

10. Adjust the DSP settings in the app as desired. Refer to the instructions starting on (page 6)

for an explanation of each tab in the app.

(refer to page 6)

Cap (with O-ring)

Case

MPS-DSPX-RC1

Circuit Board

MPS-DSPX-RC1

Harness

16-Pin 20-Pin

Gasket

Zip-tie Mounts

(Figure A)