Automobile Accessories User Manual

Kit Assembly 99-7509
9
Double DIN/Stacked ISO units provision
(Figure A)
(Figure B)
(Figure C)
1. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
2. Cut and remove the center bar from the
radio housing. (Figure A)
3. Snap the double DIN brackets to the
inside edge of the radio housing.
(Figure B)
4. Slide the double DIN or stacked ISO
unit(s) into the bracket/radio housing
assembly and secure the double DIN
or stacked ISO unit(s) to the assembly
using the screws supplied with the
unit(s). (Figure C)
5. Snap the double DIN trim plate onto the
front of the Radio Housing.
(Figure C)
6. Reassemble dash in reverse order
of disassembly.