Automobile Accessories User Manual

2
Disconnect the negative battery terminal to prevent an
accidental
short circuit. Open drivers door and remove
fuse
panel on end of dash. Open passenger door and
remove
panel on end of dash. Remove (1) Phillips screw
from
each side exposed. Remove (3) screws from top of
glove
box liner. Remove (2) screws from the top-left corner
of
the glove box cavity. Remove (1) Phillips screw from the
defroster
duct. Remove the duct work and (1) Phillips
screw
exposed. Remove the dash pad and (3) Phillips
screws
exposed at the top of the radio trim bezel. Skip to
the
Installation Instructions for ALL VEHICLES on Page
#3.
Disconnect
the negative battery terminal to prevent an
accidental
short circuit. Remove (2) 10mm bolts from
below
knee bolster under steering column and remove
panel. Remove
(2) 10mm bolts from panel below
passenger
dash airbag and remove panel. Remove (2)
10mm
nuts from inside center pocket between power
outlets. Unsnap
and remove radio and instrument cluster
panel. (May
not be necessary to completely remove radio
and
instrument cluster panel to access radio.) Remove (3)
9/32"
bolts to remove radio.
Disconnect
the negative battery terminal to prevent an
accidental
short circuit. Unclip the trim panel above the
pedals. (It
is not necessary to remove the panel, it can
remain
hanging.) Remove (2) 9/32" screws from the knee
panel
and unclip the panel. Unsnap the driver's side fuse
panel
cover and remove (1) 9/32" screw. Open the glove
box
and remove (1) 9/32" screw from the upper left corner.
Remove
(3) 9/32" screws securing the factory radio and
disconnect
the wiring.
Disconnect the negative battery terminal to prevent an
accidental short circuit. Unsnap and remove radio
bezel. Remove (3) bolts and remove radio.
1
1
1
CHEVROLET Impala 2000-2005
CHEVROLET Express Van 2001-2007
CHEVROLET Monte Carlo 2000-2005
CHEVROLET Malibu 2001-2003
5
CHEVROLET Trailblazer 2002-2007
Disconnect the negative battery terminal to prevent
an accidental short circuit. Remove (2) phillips
screws inside climate cluster. Remove (1) phillips
screw under climate controls to the left of the power
outlet. Remove (2) 9/32" screws from under
steering column, lower the panel to access (3)
phillips screws from around steering wheel and
remove. Unsnap and remove bezel. (Use caution
pulling over hazard switch.)
CHEVROLET Venture 2000-2005
GMC Envoy 2002-2007
Disconnect the negative battery terminal to prevent
anaccidental short circuit. Open cup holders and
remove (2) phillips / 7mm screws. Unsnap and
remove dual power outlet assembly from lower
storage. Open lower storage door and remove (2)
7 mm screws inside. Remove (2) 7mm screws
(facing up) from under cup holder. Remove (3)
7mm hex head screws and remove radio.
Disconnect the negative battery terminal to prevent
an accidental short circuit. Remove the climate
control knobs. Remove (1) phillips screw above
and (2) phillips screws below the climate controls.
Unclip the radio trim bezel. Remove (4) screws
from the factory head unit, slide the unit out and
disconnect the wiring.
1
Disconnect the negative battery terminal to prevent an
accidental
short circuit. Unsnap top trim of floor console
and
slide back. Remove (4) phillips screws: (2) left and (2)
right
lower from the carpeted panel. Slide carpeted panel
down
and backwards to reveal (2) phillips screws and
remove. Unsnap
radio bezel and unplug cigarette lighter
and
accessories. Remove (3) 7mm screws and remove
radio.
1
OLDSMOBILE Bravada 1998-2001
1
1
11