Technical data

8.5.2008 Rev. 2.2
Operation instructions
10
4. Operation instructions
4.1 First time use
Ensure that the mains lead does not come into contact with the hot plates (if present).
When used for the first time the appliance works according to the standard factory set-
tings. The various settings can be altered by authorised personell. See chapter ‘Settings’.
• Connect the water connection hose (supplied) to the swivel nut on the back of the
appliance and to manually-operated aeration tap. NB! Only cold water. Open the
water tap and check the connection for leaks.
• Slide an empty basket filter (3) into the appliance and place an empty jug (with lid)
underneath it. NB! For the MT200 model leave the lid of the thermos jug with
pump open, and leave the riser tube in the jug. Adjust the height of the MT200V
model before positioning it.
• Check if all on/off switches (1+2, if present) are at position 0.
• Put the plug in the socket.
• Switch on the appliance by setting the on/off switch (1) to the I position, the indi-
cator lights (5.2) and (5.3) will light up and an audible signal will sound. The dis-
play (5.1) will then show the preset standard number of cups.
• Press the start/stop button and the internal reservoir will fill up. Press the start/stop
button again if water has not started flowing after three minutes.
• The green indicator light (5.3) will now light up until the appliance has finished
making the coffee.
• When the appliance has finished making the coffee a signal will sound after about
1.5 minutes and the green indicator light (5.3) will go out.
• Follow the above steps again for the other coffee making section if the model has
a double coffee making system (M202).
• The appliance is ready for use when the jug has been emptied.