Installation Manual

A1-MT100
8
signal of the device;
2
The temperature sensing area is located in the center of the equipment base, and this
part should fit the test area during installation;
3
Press Reset button to reset the whole system; because the device is an ultra-low
power consumption device, it is usually in sleep state; if you want to use the serial
port or wireless function to modify parameters, do so within the first 30 seconds of
resetting the device; otherwise, the operation will fail;
4
Pay attention to the position of the antenna. When tightening the top cover, try not
to clamp the antenna in the metal below, otherwise the signal will be affected;
5
Before using the equipment, remove the insulating strip on the top of the button
battery to power on the equipment so that the equipment works normally; retain the
side insulating strips;
6
When installing the device, pay attention to the distance from the receiver; MT100
transmission distance is about 3 m;
7
Pay attention to the location of the equipment. If the bin is relatively large, try to
place the equipment close to the outside and keep it from metal objects as far as
possible for fear that the transmission of signals is affected.
5 Notices for Use of Equipment

Due to the limited transmission distance of MT100 which shall be no more than 3 m, it is necessary
to pay attention to the distance from MT500 or MT1100 during its installation;

MT100 is equipped with polymeric battery and shall be not allowed to contact the high temperature