Instructions / Assembly

•
Step 1
Wall lining hole should be cut or finished as
per the dimension shown in the diagram on
the right.
Cut off the threaded nipple 15±2mm from
the wall lining and apply thread seal tape
to ensure a good seal.
IMPORTANT: Before you begin, turn off the water supply.
•
Step 2
Insert faceplate o-ring into the groove in
the faceplate and slide the faceplate over
the nipple.
Secure faceplate in place by screwing the
inlet connector onto the nipple.
•
Step 3
Ensure outlet bracket o-ring is located on
faceplate.
Firmly push the outlet bracket onto the inlet
connector and secure in place by tightening the
grub screw firmly using the hex key provided.
•
•
Step 4
Connect hose to outlet bracket and handset.
Ensure swivelling cone is connected to the
handset.
•
•
•
•
•
•
•
IMPORTANT: Please read all of the instructions before installation.
General:
Methven recommends this product is installed by a licensed plumber in compliance with all
relevant regional regulations.
After installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe temperature as per
regional regulations.
It is the responsibility of the installer to ensure a waterproof seal is achieved between the
product and mounting surface. If in doubt about the quality of the seal, remove the product and
reinstall using silicone to ensure a seal is achieved.
Grub Screw
Hex Key
½" BSP Nipple
(Not Supplied)
O-ring
Faceplate
Inlet Connector
Outlet Bracket
26mm max
15±2mm
Filter Washer
Non-Swivelling Cone
Handset
Flat
Washer
Swivelling
Cone