US S1M-GW20-115 Translation of the original instructions ANGLE GRINDER
1 2 7 6 5 4 1 3 A 4 B 3 a 2 2 3
2 1 0 4 5 6 7 8 9 5 3
1. Proper usage The machine is intended for cutting, roughing, and brushing metal and stone materials without using water. For cutting metal, a special protection guard for cutting must be used. For cutting stone, a special extraction hood for cutting with cutting guide must be used. 2.
the power tool. Keep cord away from heat, oil, sharp edges and moving parts. Damaged or entangled cords increase the risk of electric shock. e) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. f) If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g) Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation.
• Hold the power tool only by the insulated gripping surfaces when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Contact with a “live” wire will also make exposed metal parts of the power tool “live” and shock the operator. • Position the cord clear of the spinning accessory. If you lose control of the power tool, the cord may be cut or snagged and your hand or arm may be pulled into the spinning accessory.
for your power tool and the specific guard designed for the selected wheel. Wheels for which the power tool was not designed cannot be adequately guarded and are unsafe. • The guard must be securely attached to the power tool and positioned for maximum safety, so the least amount of wheel is exposed towards the operator. The guard helps to protect operator from broken wheel fragments and accidental contact with wheel. • Wheels must be used only for recommended applications.
uncontrolled restarting. 5. Description of symbols • When working stone, use dust extraction. The vacuum cleaner must be approved for the extraction of stone dust. Using this equipment reduces dust-related hazards. Pay attention to all the signs and symbols shown in these instructions and on your tool. Make a note of these signs and symbols. If you interpret the signs and symbols correctly, your work with the machine will be safer and better. • Use a cutting guide when cutting stone.
6. Layout 1. 2. 3. 4. 5. 6. 7. Spindle lock ON/OFF switch Additional handle Protective cover for grinding Flange nut wrench grinding wheel:φ115*6*φ22.22(black) cutting wheel:φ115*3*φ22.22(black) 7. Before starting the equipment Before you connect the equipment to the mains supply make sure that the data on the rating plate are identical to the mains data. 7.1 Fitting the additional handle (Fig. 2) . The angle grinder must not be used without the additional handle (3). .
7) a) Clamping flang b) Flange nut • Flange arrangement when using a depressedcentre cutting wheel (Fig. 8) a) Clamping flang b) Flange nut • Flange arrangement when using a straight cutting wheel (Fig. 9) a) Clamping flang b) Flange nut 8.4 MOTOR It is vital for the motor to be well ventilated during operation. Be sure, therefore, to keep the ventilation holes clean at all times. 8.5 WHEELS • Never use a grinding or cutting wheel bigger than the specified diame er.
laced by anyone but a qualified ele trician. 11.3 Maintenance There are no parts inside the equipment which require additional maintenance. 12. Repairs Only use accessories and spare parts recommended by the manufacturer. If the equipment should fail some day in spite of our quality controls and your maintenance, only have it repaired by an authorized electrician.
