User's Manual

ITCR Locomotive Radio User Guide
© 2013 Meteorcomm LLC. All Rights Reserved. Proprietary and Confidential
4/30/2013 Do Not Distribute 13
6. Operations
This section provides commands used during normal operation of the Locomotive
radio.
6.1 Restore Factory Settings
To restore factory settings without cycling the radio:
• At the XtermW command prompt, type:
factory
6.2 Display Software and Firmware Revision Numbers
To display what software and firmware versions are installed on your radio:
• At the XtermW command prompt, type:
rev
6.3 Display Radio Identification Information
This section provides you with commands to display serial number and identification
information.
To display serial number information:
• At the XtermW command prompt, type:
serialnumber
To show current ID setting:
• At the XtermW command prompt, type:
ID