User's Manual
PRELIMINARY
FCC ID: BIB61201001
INTALLATION 3-17
PRELIMINARY
MCC-6120 SDR Packet Data Radio Network
The procedure for loading the Script File is described below:
1. Install the MCC-6120 SDR MeteorComm CD (or diskette), with the Script File on it into
your operator terminal, and load the Script File into your XTERMW\XTS subdirectory.
2. Start XTERMW and open a connection at the correct baud rate and COM port (typically
COM1, 9600 baud). All other parameters are defaults.
3. From the Scripts drop-down menu in XTERM, choose Execute Script.
4. Select the appropriate Script File in the XTERM subdirectory. Double-click the file name to
start execution.
The commands in the Script File are executed one at a time until the end of the file is reached.
Press the “up arrow” key to scroll up and review the command responses. If any commands
result in BAD COMMAND, BAD PARAMETER, or a similar message, the Script File may
have an error in it. If so, the script file needs to be corrected. Contact MCC or your System
Administrator for a replacement.
You may verify that the correct configuration file has been loaded by entering the three
commands: ASSIGN, SNP, and CONFIG.
THIS COMPLETES THE INTIALIZATION PROCEDURE