Operations Manual

OPERATIONS 4-58
O&M of the MCC-545B PACKET DATA RADIO
12/2000
†RCT{,action} Display/set remote control terminal functionality. This
functionality is applicable to Packet protocol systems
only and controls whether the unit ignores intercepted
data reports. If enabled, intercepted reports are ignored.
action =
ON – enable
OFF – disable
RED
Without parameters, generates report of current RED
setup.
†RED,ID,nn-nnn Enables reception of remote emergency indications from
an MCC Remote Emergency Device (RED). The entered
ID code is used with RED messages generated by the
545B using RED,TEST or RED,TX.
nn = call sign
prefix
nnn = call sign
suffix
0 – 99
0 – 999
†RED,NUM,n Set dead-band interval in which repeated RED
activations do not generate another alert message.
n = dead-band
interval in
seconds
1 – 120
†RED,OFF
Disable reception of remote emergency indications from
an MCC Remote Emergency Device (RED).
RED,TEST
Simulate a RED test message. Unlike a true RED test
button depression, this message is also echoed to the
local MNT and DTA ports.
RED,TX
Simulate a RED alert message. Unlike a true RED alert
button depression, this message is also echoed to the
local MNT and DTA ports.
REMCMD
,p,dest1{,…destn}
With the text editor, enter a command to be sent to a
Remote. After entering command, press [ESC] to send
the command.
p = priority
dest1…destn
destination(s)
name = node
name
nnnn = Station
ID
Master = 1 –
245
Remote = 256 –
4095
A – Z, 0 – 9
A – Z, 0 – 9
1 – 4095