Operations Manual

OPERATIONS 4-55
O&M of the MCC-545B PACKET DATA RADIO
12/2000
*P{,?}{,xxx}{,OFF} Configures 545B for pulse probe mode. If no parameters
are entered, transmit single pulse probe. Enter transmit
single pulse probe. Enter P,? to display current pulse
probe mode settings. Enter P,xxx to send a single
periodic probe once every “xxx” seconds. Enter P,OFF
to turn off periodic pulse mode (you can still transmit
single pulses with P).
? = current
settings
xxx = periodic
pulse period (in
seconds)
OFF = turn off
periodic pulse
mode
P77
The P77 command must be used to place the Julian date
into position one, and Hour/Minute into position two.
With this setup, the MCC 545B will strip off the first two
sensor values and place the date and time derived from
these values into the standard MCC 550B report.
†PASSWORDMODE,acti
on, password
Used to enable/disable use of passwords. Default is
disabled. To enable or disable the operation with
passwords, enter this command giving the desired action
along with the current password for the unit. This will
trigger an automatic "save" operation. If set to the ON
mode, the state of the unit will be set to "logged-off". All
operator and remote commands except scheduled
commands, $PENTM commands, and SDATA
commands will respond with "ACCESS DENIED!".
You will not be able to turn off the mode without first
logging on.
action =
ON – enable
OFF – disable
password = 3-20
character
password
A-Z, 0-9, -
$PENTM
Without parameter string, display report of current Entek
MDP configuration.
†$PENTM,
ALERTEVENTS{,mask}
Set bit mask indicating Entek MDP status bits regarding
as alarms. Status bits are checked against this mask on
intercepted position reports and an alert message is sent
to the local MNT and DTA ports for each match.
mask =
hexadecimal bit
mask
0 – FFFF