Operations Manual

OPERATIONS 4-38
O&M of the MCC-545B PACKET DATA RADIO
12/2000
MAINTENANCE COMMANDS
DUAL MASTER STATION COMMANDS
BOOT SHOW TXQ †SWCTL SWMON
RESET SMS
REV UPDT
UTILITY COMMANDS
SHOW RXQ FLASH HELP
WARNING/WEATHER SYSTEM
COMMANDS
DATA LOGGER COMMANDS
†FLOOD
TIMEOUT
†SENSOR P77 SDATA
†GLOF †STATION TYPE †$PENTM
†GLOF
MONITOR
†WARNING
†HORN †WARNING
TIMEOUT
†PRIORITY †WEATHER
CR10X COMMANDS
CR10X CR10X,ORDER CR10X,SETPTR
†CR10X,ACQMODE CR10X,REGISTER CR10X,SIGNATURE
†CR10X,GROUP CR10X,RESET CR10X,STAT
†CR10X,INTERVAL †CR10X,SCALE †CR10X,TIME
CR10X,MAXQ CR10X,SECURITY CR10X,UPLOAD
MASTER MODE COMMANDS
*BASE NET STAT SHOW MAINTENANCE
MONITOR
CLEAR MAINTENANCE
MONITOR
NET STAT PERIOD SHOW REMOTES
CONFIGURATION †POLL SHOW RXQ
LISTM PRG SHOW TXQ
LISTT REMOTE STAT SML
MM *REPEATER SMS
NET RX STAT TYPE
* Parameters/settings specified by these commands are stored in the EEPROM. Changes
specified by these commands take effect immediately but are lost when the unit is rebooted
unless the SAVE command is issued to write the changes to EEPROM. Changing the unit ID
automatically saves the entire configuration.
† Parameters/settings specified by these commands are stored in battery backed-up RAM.
Changes specified by these commands take effect immediately but are lost when the unit is
rebooted unless the SAVE command is issued to write the changes to BBU RAM; in addition,
the BBU jumper must be in place to enable RAM back-up.