Operations Manual

OPERATIONS 4-37
O&M of the MCC-545B PACKET DATA RADIO
12/2000
SNP,RELAY Enable/disable Master’s ability to relay messages for other destinations
The 545B, when configured as a Master Station, will report all its neighbor connectivity to its
neighbors with SNP,RELAY set ON. If it is set OFF, it will not report any neighbor
connectivity. The OFF setting keeps neighbor units from finding alternate network paths
through that node. This option should be left ON unless there is a very good reason to have it
OFF for some specific customer requirement.
4.9 Command Reference List
MCC-545B COMMANDS
All implemented 545B commands are listed in Table 4.2 alphabetically for ease of reference.
However, many commands are used in conjunction with others. These functional groups are
given below. You may also type HELP or HELP,COMMAND to receive an explanation of any
listed command. Command responses and unsolicited printouts are shown in Appendix A.
STATION CONFIGURATION
COMMANDS
STATUS
COMMANDS
MESSAGE
COMMANDS
†*ASSIGN †RCT BINS CANMSG
*BRATE †REMOTE TYPE CLS CANMSG MODE
*CHECKIN †RXTYPE CONFIG CANMSG OFF
†CLOSE PORT SAVE *HOURLIES †COMPRESSION
†CONNECT †SCALE MEM DEL MSG
DATE †SCHED MODE DQE RXQ
*DESTINATION SERIAL †MON DQE TXQ
*DEVICE *SET BAUD †MONOFF FLUSH MSG
*DUTY CYCLE †*SNP †NETMON FLUSH RXQ
*FREQUENCIES *SOURCE RELAY STAT FLUSH TXQ
†HOST MODE †START *STAT TIME *HOLD
†*ID †STOP T MESSAGE
†LOGOFF †STT TEST *MSG
†LOGON †SUBST *PRINT
*LOS CHECKIN *SYNTH REMCMD
*MODULATION TIME
†NEW
PASSWORD
†TIME ZONE
POSITION LOCATION COMMANDS
†OPEN PORT *TXLIMIT †*POS †RED
†PASSWORDMO
DE
†POSRPT †RTCM
MODE CONTROL COMMANDS
MASTER SIMULATOR COMMANDS
†CORPAT †*HALF DUPLEX *P
*FULL DUPLEX †*ROLE