User's Manual

545C Operations Manual
02/10/2012 Prerelease DCN 00001789-A
74 © 2012 Meteorcomm LLC. All Rights Reserved. Proprietary and Confidential. Do Not Distribute.
The MCC-545C will accept either a TTL or an RS-232 input from a GPS
receiver. The internal GPS uses the TTL interface and its output is
internally routed to the processor board assembly. If an external GPS is
used it may be connected to either the AUX port or the Data port using the
RS-232 interface.
5.4.1 Position Reporting Commands
The following commands are normally in a script file and are used for
configuring the MCC-545C for position reporting.
Command Description
ASSIGN,POS,p,GPS
Port selection for transmission of GPS
data.
p = Selects the desired port:
2 = External AUX, RS-232
3 = Internal TTL
SETBAUD,POS,4800,N,8,1
Set up parameters for the selected port
.
For example:
4800 = Baud rate
N = Parity
8 = Data Bits
1 = Stop Bit
POS,nn,TEXT,NMEA
nn
=
Transmit interval in seconds of a position
report to the system host.
TEXT = Binary Text
NEMA = Protocol type
Note: Each time a report is transmitted to the Host it
may also be sent to one of the local ports.
POS,LOCAL,nn
nn
=
The time interval
in seconds between reports
sent to a local port.
Note: This feature is used when more frequent position
reports are desired on a local operator terminal than
are being sent to the Host.
POSRPT,ON
ON
=
Used to display position reports from other
remotes on a local operator terminal.
OFF = Disable