User's Manual

02/10/2012
© 2012 Meteorcomm LLC. All Rights Reserved.
The following message is displayed on the operator terminal:
hh:mm:ss
Message No:
hh:mm:ss
ROUTING name :
If you wish to send a message to multiple destinations, and at a different
priority level, type:
MESSAGE
,p,dest1,dest2,...dest n
where: p
dest n
Note:
If you also want to send the
must enter its station numerical ID as one of the destination parameters
(“dest1”, “dest2”, etc.) as specified above.
There are three other special editing functions that may be used:
1.
To Retransmit the Previously E
To retransmit a previously entered message, simply press the [ESC] key
after the operator terminal prints
pressed.
The previous message entered into the Text Edit Buffer is then
sent to the destination
command.
2.
To Revise the Previously Entered Message
To revise a previously entered message, press [CTRL]
TEXT
prompt to revise a previously entered message or to recover from an
aborted session.
The
at the end of the message
3.
To Delete a Message
To delete a message after it has been placed in the Tx Queue, type:
DELMSG,ID:sss
where:
ID
sss
545C Operations Manual
Prerelease
DCN
© 2012 Meteorcomm LLC. All Rights Reserved.
Proprietary and Confidential. Do Not Distribute.
The following message is displayed on the operator terminal:
Message No:
name:ss,nnnn chars, nnn segments
ROUTING name :
sss TXT sss/nn TO: name
If you wish to send a message to multiple destinations, and at a different
priority level, type:
,p,dest1,dest2,...dest n
= any priority level from A (highest) to Z (lowest).
= numerical
ID of the stations to which the
message is routed.
If you also want to send the
message to your default destination, you
must enter its station numerical ID as one of the destination parameters
(“dest1”, “dest2”, etc.) as specified above.
There are three other special editing functions that may be used:
To Retransmit the Previously E
ntered Message
To retransmit a previously entered message, simply press the [ESC] key
after the operator terminal prints
ENTER TEXT
and before any other key is
The previous message entered into the Text Edit Buffer is then
sent to the destination
s that are now designated in the
MESSAGE
To Revise the Previously Entered Message
To revise a previously entered message, press [CTRL]
T
after the
prompt to revise a previously entered message or to recover from an
The
previous message is displayed, with the cursor placed
at the end of the message
.
You may now resume editing the message.
To Delete a Message
To delete a message after it has been placed in the Tx Queue, type:
ID
= numerical station ID
sss
= message serial number
545C Operations Manual
DCN
00001789-A
67
The following message is displayed on the operator terminal:
If you wish to send a message to multiple destinations, and at a different
= any priority level from A (highest) to Z (lowest).
ID of the stations to which the
message to your default destination, you
must enter its station numerical ID as one of the destination parameters
There are three other special editing functions that may be used:
To retransmit a previously entered message, simply press the [ESC] key
and before any other key is
The previous message entered into the Text Edit Buffer is then
MESSAGE
after the
ENTER
prompt to revise a previously entered message or to recover from an
previous message is displayed, with the cursor placed
You may now resume editing the message.
To delete a message after it has been placed in the Tx Queue, type: