User's Manual

02/10/2012
© 2012 Meteorcomm LLC. All Rights Reserved.
requires the Remote to use low
5.2.9
Network Configuration
Selecting MCC-
545C Remote/Master Operation
The MCC-
545C can
Station.
Use the DEVICE command to select the mode you require.
For normal MCC-
545C Remote Station operation, enter:
DEVICE,REMOTE
For MCC-
545C operation as a Master Station, enter:
DEVICE,MASTER
Note:
Additional MCC
is selected. If you attempt to enter a Master Station command during
Remote Station operation, you will see the error “CMD not used for this
device type.”
Selecting Network Parameters
The
Selecting Network Parameters (
FleetTrak™ and Meteor Burst networks; however, the timing parameters
need to have a much higher range (longer periods of time) for meteor burst
communication systems than in line
MCC recommends using the given default network parameters (values that
are set on power-
up or after reset)
parameters, first review the discussion in this section, then use the
following commands to change to the desir
SNP
{,pname,value}
where “pname” is the network parameter and “value” is a limit dependent
on “pname”.
The “pname” parameters are as follows:
TTL – Time-to-
live in minutes (default is 120 minutes); this is the time limit
for a message to reach
545C Operations Manual
Prerelease
DCN
© 2012 Meteorcomm LLC. All Rights Reserved.
Proprietary and Confidential. Do Not Distribute.
requires the Remote to use low
-
power mode or not.
Network Configuration
545C Remote/Master Operation
545C can
operate as either a Remote Station or as a Master
Use the DEVICE command to select the mode you require.
545C Remote Station operation, enter:
DEVICE,REMOTE
545C operation as a Master Station, enter:
DEVICE,MASTER
Additional MCC
-545C commands are available when
DEVICE,MASTER
is selected. If you attempt to enter a Master Station command during
Remote Station operation, you will see the error “CMD not used for this
Selecting Network Parameters (
SNP
) command is used in both
FleetTrak™ and Meteor Burst networks; however, the timing parameters
need to have a much higher range (longer periods of time) for meteor burst
communication systems than in line
-of-sight operations.
MCC recommends using the given default network parameters (values that
up or after reset)
.
Before you choose to change these
parameters, first review the discussion in this section, then use the
following commands to change to the desir
ed settings:
{,pname,value}
where “pname” is the network parameter and “value” is a limit dependent
The “pname” parameters are as follows:
live in minutes (default is 120 minutes); this is the time limit
for a message to reach
its destination before it is deleted from the queue.
545C Operations Manual
DCN
00001789-A
57
operate as either a Remote Station or as a Master
Use the DEVICE command to select the mode you require.
DEVICE,MASTER
is selected. If you attempt to enter a Master Station command during
Remote Station operation, you will see the error “CMD not used for this
) command is used in both
FleetTrak™ and Meteor Burst networks; however, the timing parameters
need to have a much higher range (longer periods of time) for meteor burst
MCC recommends using the given default network parameters (values that
Before you choose to change these
parameters, first review the discussion in this section, then use the
where “pname” is the network parameter and “value” is a limit dependent
live in minutes (default is 120 minutes); this is the time limit
its destination before it is deleted from the queue.