User's Manual

02/10/2012
© 2012 Meteorcomm LLC. All Rights Reserved.
Note:
The scheduler ignores certain commands due to their interactive
nature. The MESSAGE command is currently the
To remove command(s) from the schedule list, enter:
SCHED,DEL,xxx
where:
xxx
or
command
Important:
The MCC
The schedule list will be erased if the system software re
confused with power failure recovery, which will preserve the schedule
list).
You can schedule several commands to trigger at the same time;
you cannot force one command to execute before or after another
assigning commands to the schedule, the order of commands displayed in
the schedule list is the order in which the commands will trigger for any
given trigger time (i.e., a com
before an command with a higher schedule number).
5.2.6
Setting Timeout Duration
There is one programmable time limit for the I/O port input on the MCC
545C.
Use the Set Teleprinter Timeout (
for characters at the maintenance terminal, as follows:
STT,secs
where:
secs
MCC recommends using the pre
You can choose to change the timeout limit by entering the num
seconds, or you can enter a 0 to turn off the time limit.
545C Operations Manual
Prerelease
DCN
© 2012 Meteorcomm LLC. All Rights Reserved.
Proprietary and Confidential. Do Not Distribute.
The scheduler ignores certain commands due to their interactive
nature. The MESSAGE command is currently the
only one ignored.
To remove command(s) from the schedule list, enter:
SCHED,DEL,xxx
xxx
= ALL (erases entire schedule)
= schedule list number (removes single scheduled
command
from the schedule list)
The MCC
-545C currently
supports up to 50 scheduled commands.
The schedule list will be erased if the system software re
-
boots (not to be
confused with power failure recovery, which will preserve the schedule
You can schedule several commands to trigger at the same time;
you cannot force one command to execute before or after another
assigning commands to the schedule, the order of commands displayed in
the schedule list is the order in which the commands will trigger for any
given trigger time (i.e., a com
mand with a low schedule number occurs
before an command with a higher schedule number).
Setting Timeout Duration
There is one programmable time limit for the I/O port input on the MCC
Use the Set Teleprinter Timeout (
STT
) command to set the time lim
for characters at the maintenance terminal, as follows:
secs
= 0 to 32767
seconds (default is 60 seconds)
MCC recommends using the pre
-
programmed default timeout parameter
You can choose to change the timeout limit by entering the num
seconds, or you can enter a 0 to turn off the time limit.
545C Operations Manual
DCN
00001789-A
55
The scheduler ignores certain commands due to their interactive
only one ignored.
= schedule list number (removes single scheduled
supports up to 50 scheduled commands.
boots (not to be
confused with power failure recovery, which will preserve the schedule
You can schedule several commands to trigger at the same time;
however,
you cannot force one command to execute before or after another
. After
assigning commands to the schedule, the order of commands displayed in
the schedule list is the order in which the commands will trigger for any
mand with a low schedule number occurs
There is one programmable time limit for the I/O port input on the MCC
-
) command to set the time lim
it
seconds (default is 60 seconds)
programmed default timeout parameter
.
You can choose to change the timeout limit by entering the num
ber of