User's Manual

545C Operations Manual
02/10/2012
54
© 2012 Meteorcomm LLC.
To set the Power Time Out (in seconds), enter the
PTO,xxx
Note:
The PTO command must not be used (i.e., set to PTO,0) if JP4 is
installed.
5.2.5 MCC-545C
command schedule list
The SCHED command allows you to schedule the automated execution of
commands.
A schedule list simply consists of
a trigger time.
When the MCC
time, the scheduler invokes the command as though you had entered it
from the MCC-
545C’s operator terminal.
Note:
The command schedule list created by the
different than programming MCC
Appendix D for more information on programming events.
Two different types of time trigger options are provided for command
scheduling: INTERVAL and TIME
schedule a command to be invoked at periodic intervals within a 24
time period; the TIME trigger allows you to schedule a command to be
invoked only once at a specified point within a 24 hour time period
command schedule list
midnight.
To display the current schedule list, enter:
SCHED
To add a new command to the schedule list, enter:
SCHED,type,time{OFFSET,hh:mm:ss},command
where: type
time
OFFSET
,hh:mm:ss
command
Prerelease
DCN
© 2012 Meteorcomm LLC.
All Rights Reserved. Proprietary and Confidential. Do Not Distribute.
To set the Power Time Out (in seconds), enter the
following command:
The PTO command must not be used (i.e., set to PTO,0) if JP4 is
command schedule list
The SCHED command allows you to schedule the automated execution of
A schedule list simply consists of
giving one or more commands
When the MCC
-545C’s real-
time clock reaches the trigger
time, the scheduler invokes the command as though you had entered it
545C’s operator terminal.
The command schedule list created by the
SCHED command is
different than programming MCC
-545C “events” –
see Section 4.6 and
Appendix D for more information on programming events.
Two different types of time trigger options are provided for command
scheduling: INTERVAL and TIME
. The INTERVAL tr
igger allows you to
schedule a command to be invoked at periodic intervals within a 24
time period; the TIME trigger allows you to schedule a command to be
invoked only once at a specified point within a 24 hour time period
command schedule list
is restarted each time the real-
time clock reaches
To display the current schedule list, enter:
To add a new command to the schedule list, enter:
SCHED,type,time{OFFSET,hh:mm:ss},command
= INTERVAL or TIME
= hours:minutes:seconds
,hh:mm:ss
= time offset from specified
timeframe
= any MCC-
545C command (with parameters)
DCN
00001789-A
All Rights Reserved. Proprietary and Confidential. Do Not Distribute.
following command:
The PTO command must not be used (i.e., set to PTO,0) if JP4 is
The SCHED command allows you to schedule the automated execution of
giving one or more commands
time clock reaches the trigger
time, the scheduler invokes the command as though you had entered it
SCHED command is
see Section 4.6 and
Two different types of time trigger options are provided for command
igger allows you to
schedule a command to be invoked at periodic intervals within a 24
-hour
time period; the TIME trigger allows you to schedule a command to be
invoked only once at a specified point within a 24 hour time period
. The
time clock reaches
timeframe
(optional)
545C command (with parameters)