User's Manual

545C Operations Manual
02/10/2012
52
© 2012 Meteorcomm LLC.
+freq 05/18/04 08:53:50 Primary TX 044.58 MHz RX 044.58 MHz
Frequency Table
Channel
TX
>00*
044.58 MHz
01
045.90 MHz
02
000.00 MHz
03
000.00 MHz
04
000.00 MHz
05
000.00 MHz
06
000.00 MHz
07
000.00 MHz
08
000.00 MHz
09
000.00 MHz
You can select any frequency pair from the frequency table by entering the
command:
FREQUENCIES, n
where: n
= desired channel number
To set the
frequencies manually, enter the following command:
FREQUENCIES,aaaa,bbbb,xx
where: aaaa
= Tx Frequency (e.g., 4053 for 40.53 MHz)
bbbb
= Rx Frequency (e.g., 4153 for 41.53 MHz)
xx
= Frequency Channel Number in the Frequency Table (0 thru 10)
This ent
ers the above frequencies into “xx” channel number in the
frequency table.
Now select the desired channel number to make that pair
of frequencies active or the “primary” frequency pair.
Important:
If the synthesizer is unable to establish phase
command is entered, the MCC
request and turn off the TX key. It will try once a minute thereafter to
establish phase-
lock. If it fails, the message
be displayed; if it succeeds, the MCC
the TX key.
Prerelease
DCN
© 2012 Meteorcomm LLC.
All Rights Reserved. Proprietary and Confidential. Do Not Distribute.
+freq 05/18/04 08:53:50 Primary TX 044.58 MHz RX 044.58 MHz
TX
RX
044.58 MHz
044.58 MHz
045.90 MHz
044.20 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
000.00 MHz
You can select any frequency pair from the frequency table by entering the
= desired channel number
frequencies manually, enter the following command:
FREQUENCIES,aaaa,bbbb,xx
= Tx Frequency (e.g., 4053 for 40.53 MHz)
= Rx Frequency (e.g., 4153 for 41.53 MHz)
= Frequency Channel Number in the Frequency Table (0 thru 10)
ers the above frequencies into “xx” channel number in the
Now select the desired channel number to make that pair
of frequencies active or the “primary” frequency pair.
If the synthesizer is unable to establish phase
-
lock when
command is entered, the MCC
-545C will respond
ON, UNLOCKED
request and turn off the TX key. It will try once a minute thereafter to
lock. If it fails, the message
SYNTHESIZER UNLOCKED
be displayed; if it succeeds, the MCC
-545C will respond
LOCKED
DCN
00001789-A
All Rights Reserved. Proprietary and Confidential. Do Not Distribute.
+freq 05/18/04 08:53:50 Primary TX 044.58 MHz RX 044.58 MHz
You can select any frequency pair from the frequency table by entering the
frequencies manually, enter the following command:
= Frequency Channel Number in the Frequency Table (0 thru 10)
ers the above frequencies into “xx” channel number in the
Now select the desired channel number to make that pair
lock when
the
ON, UNLOCKED
to the
request and turn off the TX key. It will try once a minute thereafter to
SYNTHESIZER UNLOCKED
will
LOCKED
and turn on