User's Manual

02/10/2012
© 2012 Meteorcomm LLC. All Right
4.
From the
Script.
5.
Select the appropriate Script File in the
Double-
click the file name to start execution.
The commands in the Script File are executed one at a time until the
end of
the file is reached
review the command responses
COMMAND, BAD PARAMETER, or a similar message, the Script File may
have an error in it
MCC or your System Administrator for a replacement.
You may verify that the correct configuration file has been loaded by
entering the three commands:
THIS COMPLETES THE INTIALIZATION PROCEDURE
4.4
Operational Test Procedure
Note:
Be sure to connect the antenna if it was disconnected per the
CAUTION note of Section 3.3.
4.4.1 RF Test
A very thorough RF test can be made by entering the command TEST
[ENTER].
TEST causes the processor to turn the transmitter ON and
measures the
forward and reverse RF power that is being transmitted
also measures the battery voltage under load and the antenna noise
voltage.
545C Operations Manual
Prerelease
hts Reserved.
Proprietary and Confidential. Do Not Distribu
From the
Scripts pull-down menu in XTermW
, choose Execute
Select the appropriate Script File in the
XTermW
subdirectory
click the file name to start execution.
The commands in the Script File are executed one at a time until the
the file is reached
.
Press the “up arrow” key to scroll up and
review the command responses
.
If any commands result in BAD
COMMAND, BAD PARAMETER, or a similar message, the Script File may
have an error in it
.
If so, the script file needs to be corrected
MCC or your System Administrator for a replacement.
You may verify that the correct configuration file has been loaded by
entering the three commands:
ASSIGN, SNP, and CONFIG
.
THIS COMPLETES THE INTIALIZATION PROCEDURE
Operational Test Procedure
Be sure to connect the antenna if it was disconnected per the
CAUTION note of Section 3.3.
A very thorough RF test can be made by entering the command TEST
TEST causes the processor to turn the transmitter ON and
forward and reverse RF power that is being transmitted
also measures the battery voltage under load and the antenna noise
545C Operations Manual
DCN 00001789-A
ibute.
39
, choose Execute
subdirectory
.
The commands in the Script File are executed one at a time until the
Press the “up arrow” key to scroll up and
If any commands result in BAD
COMMAND, BAD PARAMETER, or a similar message, the Script File may
If so, the script file needs to be corrected
. Contact
You may verify that the correct configuration file has been loaded by
.
THIS COMPLETES THE INTIALIZATION PROCEDURE
Be sure to connect the antenna if it was disconnected per the
A very thorough RF test can be made by entering the command TEST
TEST causes the processor to turn the transmitter ON and
forward and reverse RF power that is being transmitted
. It
also measures the battery voltage under load and the antenna noise