User's Manual

545C Operations Manual
02/10/2012
36
© 2012 Meteorcomm LLC.
Use the following command to display what device type the unit is
configured as:
DEVICE [ENTER]
Always check with your System Administrator to determine which device
type
your unit should be configured as.
For example, if the device should be a Remote Station and it is not
currently configured properly, you can change the device type, as
follows:
DEVICE,REMOTE [ENTER]
SAVE [ENTER]
Caution:
Do not change the device type u
Administrator. Changing the device type can make your unit cease operating
and can impact communications throughout the entire network.
Verify ID Number
Every MCC unit is programmed at the factory with a 16
display the unit ID number on the operator terminal, enter:
ID [ENTER]
Contact your System Administrator to make sure this ID is registered in
the network configuration database
may have to be changed on
locked.
Caution:
ID changes must be coordinated with both MCC and your System
Administrator. Failure to do so may result in data or messages being
misrouted or lost. Refer to Section 4.1.4.1 for more information on unit ID
settings.
Verify Frequency
The MCC-
545C is programmed at the factory with the authorized
frequencies to be used in your network
Parameter memory and cannot be changed
frequency is configured by enter
Prerelease
DCN
.
All Rights Reserved. Proprietary and Confidential. Do
Use the following command to display what device type the unit is
Always check with your System Administrator to determine which device
your unit should be configured as.
For example, if the device should be a Remote Station and it is not
currently configured properly, you can change the device type, as
DEVICE,REMOTE [ENTER]
Do not change the device type u
nless told to do so by your System
Administrator. Changing the device type can make your unit cease operating
and can impact communications throughout the entire network.
Every MCC unit is programmed at the factory with a 16
-
bit unit ID
display the unit ID number on the operator terminal, enter:
Contact your System Administrator to make sure this ID is registered in
the network configuration database
.
Under some circumstances the ID
may have to be changed on
-site. This can o
nly be done if the ID is not
ID changes must be coordinated with both MCC and your System
Administrator. Failure to do so may result in data or messages being
misrouted or lost. Refer to Section 4.1.4.1 for more information on unit ID
545C is programmed at the factory with the authorized
frequencies to be used in your network
.
These frequencies are stored in
Parameter memory and cannot be changed
.
Verify that the correct
frequency is configured by enter
ing the command:
DCN
00001789-A
Do Not Distribute.
Use the following command to display what device type the unit is
Always check with your System Administrator to determine which device
For example, if the device should be a Remote Station and it is not
currently configured properly, you can change the device type, as
nless told to do so by your System
Administrator. Changing the device type can make your unit cease operating
and can impact communications throughout the entire network.
bit unit ID
. To
Contact your System Administrator to make sure this ID is registered in
Under some circumstances the ID
nly be done if the ID is not
ID changes must be coordinated with both MCC and your System
Administrator. Failure to do so may result in data or messages being
misrouted or lost. Refer to Section 4.1.4.1 for more information on unit ID
545C is programmed at the factory with the authorized
These frequencies are stored in
Verify that the correct