User's Manual

545C Operations Manual
02/10/2012 Prerelease DCN 00001789-A
170 © 2012 Meteorcomm LLC. All Rights Reserved. Proprietary and Confidential. Do Not Distribute.
COMMAND DESCRIPTION PARAMETERS RANGE
$PENTM Without parameter string, display report of
current Entek MDP configuration.
†$PENTM,
ALERTEVENTS{,mask}
Set bit mask indicating Entek MDP status bits
regarding as alarms. Status bits are checked
against this mask on intercepted position reports
and an alert message is sent to the local MNT
and DTA ports for each match.
mask = hexadecimal bit mask 0 – FFFF
†$PENTM,ALERTMSGS
{,nnn...}
Define canned messages constituting an alert.
Any number may be defined (up to 10 per line).
Intercepted messages matching one of these
numbers cause an alert message to be sent to
the local MNT and DTA ports.
nnn = canned message
number
1 – 120
$PENTM,command string Send command string to local Entek MDP. command string = any valid
Entek MDP command string
†$PENTM,action Enable/disable Entek MDP interface. When
enabled, allows communication with mobile
data processor in vehicle tracking applications
and causes received status bits from the MDP to
be included with the position data in the
Remote's data reports.
action =
ON – enable
OFF – disable