User's Manual

545C Operations Manual
02/10/2012 Prerelease DCN 00001789-A
© 2012 Meteorcomm LLC. All Rights Reserved. Proprietary and Confidential. Do Not Distribute. 125
COMMAND DESCRIPTION PARAMETERS RANGE
†*ASSIGN
{,function,port,protocol
{,timeout}}
NOTE
function, port and protocol
information for ports 0, 1, 2
are stored in CPM; this
information for port 3 and all
timeout information is stored
in BBU RAM.
Control allocation of user interface functions
among physical device channels. When no
parameters are entered, displays I/O
configurations. Port definitions are as follows:
Front Panel
Port Connector
0 OPERATOR PORT
DATA PORT
2 AUXILIARY PORT
3 DIAGNOSTICS PORT
(Internal)
NOTE
It is possible to “lose control” of the 545C
software by assigning control functions to ports
with no devices attached or by turning off
control functions. For example, if you turn off
the Operator Port (ASSIGN,MNT,OFF), you will
not be able to enter commands or view
printouts from the 545C. You must open the
545C and press the Reset button on the
microprocessor board to re-enable the Operator
Port.
function = user interface
function
port = physical device
channel
protocol = link level
protocol
timeout in seconds
MNT, DTA, ALT,
POS
0-2, OFF
ASCII,F
WS,GPS,IHS,MSC,P
HAROS,IDA,PKT,D
ATALITE, AEI
RTCM,APCL5,CR10
X,ENAV,TRAN,GYR
O,H350,DIRECT,
UAIS,
PAKBUS,SERPT,CR
10XTD,DG1100,GE
NERIC,
SOUNDER
0 – 32767