User's Manual

545C Operations Manual
02/10/2012 Prerelease DCN 00001789-A
© 2012 Meteorcomm LLC. All Rights Reserved. Proprietary and Confidential. Do Not Distribute. 123
CR10X,MAXQ
CR10X,SECURITY
CR10X,UPLOAD
MASTER MODE COMMANDS
*BASE
NET STAT
SHOW MAINTENANCE
MONITOR
CLEAR MAINTENANCE
MONITOR
NET STAT PERIOD
SHOW REMOTES
CONFIGURATION
†POLL
SHOW RXQ
LISTM
PRG
SHOW TXQ
LISTT
REMOTE
STAT
SML
MM
*REPEATER
SMS
NET
RX STAT
TYPE
* Parameters/settings specified by these commands are stored in Parameter Memory (CPM). Changes
specified by these commands take effect immediately but are lost when the unit is rebooted unless the
SAVE command is issued to write the changes to the non-volatile Flash memory. Changing the unit ID
automatically saves the entire configuration.
† Parameters/settings specified by these commands are stored in battery backed-up Data Memory
(RAM). Changes specified by these commands take effect immediately but are lost when the unit is
rebooted unless the SAVE command is issued to write the changes to RAM; in addition, the connector
J1 must be in place to enable RAM back-up.
If both symbols are present on a command, certain aspects are stored in one way and other aspects are
stored in the other. See command table below for clarifications.